|
|
|
|
 |
|
|
|
 |
|
 |
|
|
| Objects | page : 1 |
|
ajm.busymap
| Abstraction |
  |
visualization of poly~ busymap |
|
ajm.polyroute
| Abstraction |
|
route messages to poly~ targets with OSC syntax
Depends on the OSC-route object (http://cnmat.berkeley.edu/downloads) |
|
fc.BP.Link
| Abstraction |
 |
link the masses create with the poly-B.P.particule2
include in a poly~object, permitted to make different links between the masses create with the poly-B.P.particule2 |
|
flushp
| Abstraction |
|
flush is not only flushing, its also unpacking. For those cases where you'd need to pack the values again, like for poly~s, flushp does this. |
|
in
| External |
 |
Define a message input in a patcher loaded by poly~ |
|
in~
| External |
|
Define a signal input in a patcher loaded by poly~ |
|
out
| External |
|
Define a message output in a patcher loaded by poly~ |
|
out~
| External |
|
Define a signal output in a patcher loaded by poly~ |
|
Poly-B.P.particule2
| Abstraction |
|
used with pmpd 2D objects, create/delete mass, control, bounds, collision detection & receive
abstraction include in a poly~ object for create/delete mass in a limited space, control physics properties by group or individual, and receive values. |
|
polyline
| Abstraction |
|
non-audio use of poly~ |
|
poly~
| External |
|
Polyphony and DSP manager for patchers |
|
Simple FM Synth
| Patch |
|
A simple FM synthesize patch
First off, I should mention that the name is a bit of a misnomer. There are really two layers, the titular simple FM layer, and a subtractive synth layer. Simple FM Synth is nothing fancy, but I think it sounds pretty good, for what it is. This patch started off as a basic sound source to enable me to work on the Gyre program that I use with my Buchla 200e, when I was not near my Buchla.
There are two main patches of interest, Simple_FM_Synth.maxpat, and Simple_FM_Synth_Test.maxpat. Simple_FM_Synth is what you'll use in your patches, and Simple_FM_Synth_Test is an example of ways to use it. Simple_FM_Synth_Test has a simple note generator that plays randomish notes so that you can start it playing, and then mess with the parameters of Simple_FM_Synth itself.
The FM section is a simple two-operator stack, nothing fancy here. There are a couple redundant ways to set the relationship of the FM carrier and FM modulator.
The Subtractive section consists of two oscillators, one square/pw, and one sawtooth, mixed into a filter. Even though the poly~ patch "FMSynthVox.maxpat", as delivered, uses svf~, the presets were written using 2up_svf~ instead. 2up_svf~ sounds better than the stock svf~, in my opinion, but it is only available for the Mac, so I used the stock object for this distribution. The presets are somewhat different sounding with the stock svf~. If you are on a Mac, I highly recommend grabbing 2up_svf~ from here, and editing FMSynthVox to use it.
Chris Muir |
|
thispoly~
| External |
|
Reports poly~ instance number, controls voice allocation and muting |
| page : 1 |
|
|
|
 |
|
 |
|
|
|
|
|
|
